Gig Harbor Auto Repair

This may have happened to you.  You drive somewhere and get out of your vehicle only to try closing the door and it just won't stay closed!  What a helpless feeling.  You can't lock it; you can't leave it like it is. Or, let's say you head down to your vehicle to head out to work in the morning and you can't open the door.  What are you going to do now? Vehicle doors take a lot of abuse.  They are opened and closed hundreds of times and we expect them to just keep working perfectly all the time.  They do require a bit of tender loving care.  Let's take a look at two different scenarios of stuck doors. First: the door that won't close.  It's a security issue.  It's also a safety issue.  You can't really safely drive a vehicle with a door that won't close. What if you or a passenger is tossed out?  Sure, some people try to tie a stuck-open door closed or bungee it, but that's dangerous.  It's best to get that vehicle to the serv ... read more

You may notice that when you get your vehicle's oil changed, your service adviser may recommend that you have your tires rotated at the same time.  The reasons are simple.  That will allow your tires to wear more evenly and reduce the noise your tires make as you drive down the road. There are different ways of rotating tires. If your vehicle has non-directional tires and the same size wheels at each corner, here are the different rotation patterns. For all-wheel drive and rear-wheel drive vehicles, one is called the rearward cross pattern.  The rear tires are moved to the front and stay on the same side of the vehicle, and the front tires are moved to the rear on the side opposite of where they were on the front.  For all-wheel and four-wheel drive vehicles, use the X pattern.  The rear tires are moved to the front on the opposite side of the vehicle, and the fronts are moved to the rear on the opposite side of where they were on the front. For front-wheel dri ... read more

Most GIG HARBOR drivers know something about preventive maintenance on a vehicle. We know we should routinely replace the oil and wiper blades and other fluids. But have you heard of a PCV valve ? This little car part needs to be replaced regularly or it can cause some serious problems in your vehicle engine.PCV stands for Positive Crankcase Ventilation. The crankcase holds your motor oil and is located at the bottom of your engine.When fuel is burned in your engine, it produces waste gases that are mostly vented out through your exhaust system. But some of these gases push their way past the pistons and into the crankcase. There, these gases can mix with motor oil to produce oil sludge, which can damage vehicle engine parts through corrosion and by clogging engine passages. GIG HARBOR vehicle owners should be advised that if the engine is running at high speeds, these gases can also cause pressure inside the crankcase to build up. This pressure, in tu ... read more

When the weather turns cold, it's nice to crank up the furnace and enjoy the heat. But if your home's furnace doesn't work, it's not too comfortable. Same goes with your vehicle. When the heater's not working, things can get miserable. It could also signal some major problems, which we'll discuss later. A vehicle's heating system is fairly complicated. It's made up of several parts, including a blower motor/fan, a heater core and some mechanical and electrical components. In basic terms, a vehicle's engine warms up coolant which is then sent to the heater core (which is kind of like a small radiator) behind the dash. That blower motor sends cold air through the heater core which heats up the air. Voila! Heat. Diagnosing problems in this system takes a trained mechanic because of the different possible issues. Your heater core may need replacing; they are sometimes in tight spots and may be difficult to work on. Another possible problem could be a defective thermostat, which regulates h ... read more

Of the things you think about most, your tires are probably pretty far down the list. That’s understandable because today’s tires are engineered to do their job without needing you to pay too much attention to them. But they DO wear out, and worn tires can contribute to skidding in bad weather, not being able to stop, a ride full of uncomfortable vibrations and, even a sudden blowout. Yikes. Let’s figure out right now how to know if your tires need replacing! Let’s face it. Most of us don’t know the first thing about tires. So, the best way to make sure what shape yours are in is to take your vehicle to a qualified service facility to have the tires checked out by a trained technician.  Here are things they’ll check: Tread.  Tread is the part of the tire that touches the road surface.  Different tires have different tread patterns and something called tread blocks - the raised rubber parts that contact the road. The longer a tire has ... read more

You spend a lot of money on a vehicle, probably the most money you'll spend on anything except a house.  But the spending doesn't stop after you've bought it.  It goes into things like insurance, repairs and fuel.  One good piece of news is that you can cut down the amount you spend on fuel if you follow a few tips. Keep your speed under 50 mph/80 kph.  Anything over that and your fuel economy will go down quickly the faster you go.  Sure, you can legally drive  faster than that, but practice this one tip and it can save you from 7%-14% on fuel. Use cruise control.  The steady speed increases fuel economy by avoiding unnecessary braking and accelerating.  If your vehicle is carrying unnecessary weight, unload it.  If you can save 100 pounds/45 kilograms, it can save you 1% of your fuel.  Don't idle.  Let's say you're sitting in a parking lot with your engine running for 10 seconds.  Any more and you're wasting fuel.  Turn ... read more

You probably have heard that expression, "A stitch in time saves nine." In other words, if you fix an issue at its early stages, it will prevent a much more difficult problem later. That's certainly the case with your vehicle, and here's a true story to demonstrate it. A driver noticed his vehicle was due for an oil change, so he took it in to his service facility early in the morning so he could wait while the work was performed. The technician routinely checks the battery on vehicles just before extreme weather is approaching (cold or hot), so with winter coming up, he hooked up the load tester (it measures voltage while a load is put on the battery). It showed the battery wasn't holding a charge well. The technician checked the manufacturing date on the battery, too (most batteries have a date stamped in code somewhere on them). The date showed it was five years old. While batteries can last more than five years, many technicians say you should expect to get anywhere from three to s ... read more

The automotive professionals at Mackert Automotive LLC would like to give GIG HARBOR drivers an update on some of the things happening in automotive fluids. You know, vehicles are becoming more sophisticated every day.  Fluids such as, oil, coolant and transmission fluid are becoming more specialized at about the same pace.The GIG HARBOR do-it-yourselfer has to be pretty careful so that they do not actually harm their vehicle with the wrong type of fluid. That is why so many WA ] owners rely on the advice of their friendly and knowledgeable Mackert Automotive LLC service advisor to not only get the correct family of fluids, but to suggest the formulation that is best for their vehicle and their driving habits in the GIG HARBOR area.Let's start with engine oil. GIG HARBOR drivers who have been paying attention will have noticed a number of new oil weights on the WA scene in the last several years. Mod ... read more

Bet you didn't know: Some of the earliest rearview mirrors were marketed as "Cop Spotters" so drivers would know when police were following them. Who wants a ticket, anyway? According to eBay Motors, Elmer Berger first patented a rearview mirror that was mounted on the front fenders, on the spare tire secured to the side of the car of at the top of the driver's door frame.  About 80 percent of your vehicle is recyclable. So says The Balance. That means four-fifths of most vehicles can be recycled.  Much of that recycling is done by automotive aftermarket recyclers.  Between the U.S and Canada, they reclaim enough steel to produce 13 million new vehicles. The man who invented the first modern cruise control couldn't even drive a car because he was blind! His name, says Smithsonian.com, was Ralph Teetor.  Blinded at a young age by a knife accident, Teetor was inspired to create a speed control by a couple of things.  One, the U.S. imposed a mandatory 35 mph/55 kp ... read more

Brakes are one of your vehicle's most important safety components, and you may have noticed that they don't stop as surely as they used to.  Maybe it takes you applying a little more pressure to them than before, or perhaps you get the feeling that they're not stopping you as quickly. Those could be signs that your brake fluid needs changing.  Hydraulic brake systems use a fluid that enables the brakes to apply their stopping power to the wheels.  That fluid can wear out, degrade, become contaminated or pick up air and moisture.  All those can eventually contribute to brakes that feel sluggish. Driving with old, worn-out brake fluid may also shorten the lifespan of other braking components. Our technicians can evaluate your brake fluid to see if it needs changing. Your vehicle's manufacturer recommends how often that should be done, and when it needs changing may depend on how and where you drive. Our technicians can check the condition of your brake fluid when you ... read more