Gig Harbor Auto Repair

You know you have an accelerator pedal; step on it and your vehicle is supposed to go.  But did you know there is a part in your vehicle that keeps track of where the throttle is? It's called the Throttle Position Sensor, or TPS. The TPS is a sensor that helps your vehicle figure out the right mix of air and fuel is reaching your engine.  It does that by keeping track of the throttle and sending that information to your vehicle's computer.  Other factors play a role in how well your engine is performing, including air temperature, how fast the engine is turning over and air flow.  When the TPS isn't working right, you may find your vehicle won't accelerate or doesn't have the power you're expecting when you press on the accelerator.  In some cases, it may accelerate on its own.  Sometimes your vehicle won't go over a certain speed.  Your Check Engine light may go on. Any of these symptoms should be checked out soon.  If your TPS stops working rig ... read more

If someone asked you what gas made up the largest portion of the atmosphere, what would you guess? Well, it's not oxygen; it only makes up 20.9 percent.  But since we're talking about oxygen, you should know that your vehicle uses oxygen sensors to make sure your engine is running the way it should. The oxygen sensors measure how much oxygen is in your exhaust.  If there's too much, it means there's a problem with the mixture of fuel and air.  The sensor sends signals to computers in your engine and adjusts the mixture so it maximizes performance and efficiency.  It does this constantly.  Many vehicles have multiple oxygen sensors.  Some have one close to the engine, another close to the muffler.  Two measurements are better than one since they allow readings to be more accurate.  You may have a vehicle with a dual exhaust, so you'd have twice as many oxygen sensors. Your oxygen sensors can fail.  One thing that can damage them is contaminat ... read more

When you start up your gasoline engine car, you may not know that it's using the same ignition principles as it has for decades.  You have spark plugs that require enough power so a spark can jump across a gap at its tip.  Years ago, a vehicle's 12-volt system had to produce 15,000-25,000 volts to do that, so engineers came up with something called an ignition coil that bumps up the voltage. It also has to be done at just the right interval called timing. The first systems had a distributor, a mechanical device with a rotating disc that switched the power to the ignition coil on and off.  That higher voltage then was sent to the spark plugs at the correct time interval. But the mechanical "points" had to be replaced and adjusted every 12,000 miles/20,000 kilometers.  Engineers later replaced the switching mechanism with solid state ones, but they still needed replacement after 120,000 miles/200,000 kilometers. The next evolution came in the 80's when the distributor ... read more